Iec Motor Starter Size Chart. To start the motor, do not exceed the maximum as listed in exception no. Please check motor drawing for actual dimensions.

Sizing Motor Starters from www.industrial-electronics.com

Full load amps (fla) wire size; 2 only available on an56 reversing starters. Starter selection chart basic starter size selection is based upon the horsepower and voltage of the motor the starter is controlling.

Table of Contents

Allen Bradley 100 C12D10 Contactor Iec A112 Iec Contactors Starters Enclosed Starters Selection Motor Contactars And Overload Relays 140M C2E A40 Motor Protection Circuit.

However, above 100a, the physical differences are negligible. Frame l449t is not included in this chart. Iec motor data calculator is based on the nec 2011.

Industrial Electric Motors And Drives Key And Keyseat Dimensions Framedgfgd Framedgfgd 63 11 8.5 44180 48 42.5 14 9 71 14 11 55200 55 49 16 10 80 19 15.5 66225 60 53 18 11 90 24 20 87250 70 67.5 20 12 100 28 24 87280 80 71 22 14 112 28 24 87315 85 76 22 14 132 38 33 10 8 355 85 76 22 14 160 37 4 2 8 *Contact Your Local Baldor Office For “L” Dimensions.

Xt iec overload relays contactors and starters eaton. However, in larger sizes, they can vary enough to cause concern in some design applications. Contactor size & line power.

Starter Selection Chart Basic Starter Size Selection Is Based Upon The Horsepower And Voltage Of The Motor The Starter Is Controlling.

For either higher output and larger size motors and/or other speeds or voltages, please contact our special products department. (see table a footnote.) in this case, nema calls for 75 hp in the frame size in which iec calls for 50 hp. Follow these steps in order to select the proper motor starter for your requirements:

Normally, An Iec Starter Is Almost Half The Size Of A Similar Nema Starter.

It still has kept its motor meps from 0.75 kw to 375 kw at the ie2 level with the date of the formal enforcement of the more advanced meps with ie3 and ie4 as a reach standard. Typical single phase & three phase motor data: Cage, 3 phase, induction motors lower than 1000v and smaller than 315 frame size can safely run continuously at the speed in the table below.

See also  Nema Motor Starter Size Chart

Iec Frame Motors Farm ­ Duty Motors Definite ­ Purpose Motors Unit ­ Handling ­ Motors Brake ­ Motors 200 ­ & ­ 575 ­ Volt Motors Iec ­ Frame Motors 50 ­ Hertz Motors Inverter/Vector Motors ­ & ­ Controls Dc ­ Motors And ­ Controls Soft ­ Start ­ & ­ Dynamic ­ Brakes Metric Iec Frame Motors, Three Phase, 60 Hz Iec Frame Ø D E F G H L Q R V Y Z D 63 11 23 4 8.5 4 130 222 81 7 120 75 M4 71.

Refer to your motor or equipment nameplate to verify the full load amperage. 2 only available on an56 reversing starters. A quick chart for starter sizes is provided here, to the right.